PASCO ME-9486 BALLISTIC CART ACCESSORY - Manual (Page 7)

3
012-05460A Ballistic Cart Accessory
ME-9486 Ballistic Cart Accessory
Battery Installation
➀
Turn the unit on its side and install the 9-volt battery
in the bottom of the unit. See Figure 1.
Attaching the Ballistic Cart Accessory to a Dynamics
Cart
➀
Remove the two mounting screws (see Figure 2) from
their storage place on the side of the unit. (There are
two extra screws included with the Ballistic Cart Ac-
cessory.) Use these screws to attach the Ballistic Cart
Accessory to the mass tray of the dynamics cart.
Assembly
“ON” LED
battery
holder
bottom of
unit
Figure 1: Battery Installation
AIM ADJUST
DROP
ROD CLAMP
DROP
ROD JACK
AIM ADJUST
➁
Slide the photogate trip bracket into the T-slot on the
dynamics track. See Figure 3.
Figure 2: Ballistic Cart Installation
Dynamics Cart
thumbscrews
(2)
power
switch
aim adjust
screws
Ballistic Cart
Accessory
thumbscrew
storage
Drop Rod
jack
INSTRUCTIONS
1. MOUNT UNIT ON CART.
2. TURN UNIT ON.
3. INSERT AND DEPRESS BALL.
4. INTERRUPT PHOTOGATE TO LAUNCH
BALL.
AIM ADJUST
FORWARD - BACK
TURN UNIT OFF WHEN NOT IN USE
9V BATTERY LOCATED UNDER
MOUNTING BRACKET
DROP ROD JACK
ON
POWER OFF
PASCO
scientific
DYNAMICS
CART
ME-9430
Figure 3: Using the Trip Bracket
nylon
thumbscrew
bracket
“L” bracket
bracket
thumbscrew
dynamics cart
track
square nut
Dynamics
Cart
assembled
trip bracket
Ballistic Cart
Accessory
ball launcher
photogate