PASCO ME-9838 Hovercraft - Manual (Page 9)

Model No. ME-9838 Hovercraft
9 ®
13. Pull the two ends taut until the skirt is held firmly in the groove of the rubber bumper.
Have another person walk around the bumper to be sure the skirt is in the groove as the
wires are pulled taut.To prevent leaks make sure the wires are cinched up very tight.
14. Trim the wires from each side of the gripple. Be sure the sharp wires do not stick out!
15. Using the included wood screws, attach the air source adapter to the top of the wood
platform (See Figure 4).
16. Use glue or double-sided tape to affix the bubble level to the top of the wood platform.
Place the level away from the center of the platform, so the rider can view the level easily
(See Figure 4)...
Figure 3. Gripple Detail
Flat Washer
Skirt
Rubber Washer
Flat Washer
Top of Wood Platform
Figure 4. Exploded View
Figure 2. Attach center of skirt
Skirt
Rubber Bumper
Wood Platform
Air Source Adapter
Bubble Level
Cap Nut
Flat Head Screw