PASCO SF-9214 Precision 2.0 Meter Air Track - Manual (Page 5)

scientific
012-02149B
1
Equipment
Introduction
The PASCO Model SF-9214 Air Track is 2.0 meters
long with a guaranteed straightness to within .04 mm
over its entire length. The track construction is a large
square aluminum extrusion of 3 mm thick walls that
are further strengthened by a supporting U-channel.
A single foot support at one end and a double foot at
the other end allows for lengthwise and sideways
leveling.
Unpacking and Setup
The SF-9214 Air Track is shipped in two containers, a
large tube (containing the track) and a cardboard box
(containing the accessories).
Gently remove one end from the air track shipping tube
and carefully pull the track, with the alignment beam
attached, from the tube.
➧
CAUTION: Use care not to scratch or nick the
upper surfaces of the track. (Those containing the
airholes.) Any protrusion on this surface may
impede the motion of the glider.
Air Track
Middle Layer
Bottom Layer
Envelope
Top Layer
Equipment included:
• 2 m Air Track
Accessories:
Envelope:
• 2 (100 mm) Flags
Top Layer:
• 1 Accessory tray
Middle Layer:
• 2 Gliders
• Mounting hardware (2 single leg screws, 2 double
leg screws, (1) 4 mm wrench, (1) 5 mm wrench)
Bottom Layer:
• 1 Single leg
• 1 Double leg w/adjustable feet
• 2 End Stops
Additional Equipment Required:
• Air Supply (Model SF-9416)
Accessories Box