PASCO ME-8961 ADDITIONAL GYROSCOPE DISK - Manual (Page 2)

2
Additional Gyroscope Disk 012-05330B
Limited Warranty
PASCO scientific warrants this product to be free from
defects in materials and workmanship for a period of one
year from the date of shipment to the customer. PASCO
will repair or replace, at its option, any part of the product
which is deemed to be defective in material or workman-
ship. This warranty does not cover damage to the product
caused by abuse or improper use. Determination of
whether a product failure is the result of a manufacturing
defect or improper use by the customer shall be made
solely by PASCO scientific. Responsibility for the return
of equipment for warranty repair belongs to the customer.
Equipment must be properly packed to prevent damage
and shipped postage or freight prepaid. (Damage caused
by improper packing of the equipment for return ship-
ment will not be covered by the warranty.) Shipping
costs for returning the equipment, after repair, will be
paid by PASCO scientific.
Equipment Return
Should this product have to be returned to PASCO
scientific, for whatever reason, notify PASCO scientific
by letter or phone BEFORE returning the product. Upon
notification, the return authorization and shipping instruc-
tions will be promptly issued.
➤ NOTE: NO EQUIPMENT WILL BE AC-
CEPTED FOR RETURN WITHOUT AN AU-
THORIZATION.
When returning equipment for repair, the units must be
packed properly. Carriers will not accept responsibility
for damage caused by improper packing. To be certain
the unit will not be damaged in shipment, observe the
following rules:
➀
The carton must be strong enough for the item
shipped.
➁
Make certain there is at least two inches of packing
material between any point on the apparatus and the
inside walls of the carton.
➂
Make certain that the packing material can not shift in
the box, or become compressed, thus letting the instru-
ment come in contact with the edge of the box.
Using the Rotating Disk Pulley
➀
Make sure the rotating disk is secure on the gyro-
scope axle and decide which direction you want the
disk to rotate.
➁
Tie a loop in the end of a length of thread (approxi-
mately 1.5 meters long) and put the loop around the
dowel pin located on the surface of the rotating disk
pulley and wind the thread around the surface of
the pulley. See Figure 2.
➂ Holding the gyroscope axle in place, pull the thread
to rotate the disk at the desired speed.
gyroscope
axle (part of
ME-8960)
pulley
thread
rotating disk
dowel pin
Figure 2: Using the Rotating Disk Pulley