PASCO ME-9869 Fan Accessory Guard (5 pack) - Manual

Instruction Sheet
for the PASCO
Model ME-9869
FAN ACCESSORY GUARD PACK (5)
Installation Instructions
012-08714A
© 2003 PASCO scientific
Introduction
The ME-9869 Fan Accessory Guard Pack provides
the parts necessary for updating the ME-9491 Fan Ac-
cessory with a protective fan guard and to decrease its
vibration on the Fan Cart.
Equipment
Included equipment
• (2) Fan Guard Covers
• (4) 1 inch TORX Head Screws
• (3) 1/4 inch Phillip Head Screws
• (4) 6X3/8 Phillips Head Screws
• (4) .25 Diameter Flat Washer
• (1) T-8 TORX L-Wrench
Additional required equipment
• Phillips Head screwdriver
Attaching the Protective Fan Guard
1. The propeller / propeller bushing is press fit to the
motor shaft of the ME-9491 Fan Accessory. Re-
move the propeller from the unit by pulling the
propeller assembly straight from the main body.
2. Use the Phillips screwdriver to remove the two
small screws located next to either side of the mo-
tor shaft. Be careful not to shake the housing. Dis-
card these screws.
Figure 1. Attaching the Fan Guard to the Fan Accessory
better
teach science
ways to
Phone (916) 786-3800 • FAX (916) 786-8905 • web: www.pasco.com
10101 Foothills Blvd. • P.O. Box 619011 • Roseville, CA 95678-9011 USA
®
fan guard cover
fan guard cover
propeller
1/4 inch Phillips
head screw
1 inch TORX
head screw
housing