PASCO ME-9470 ADJUSTABLE DYNAMICS TRACK FOOT - Manual

Setup Procedure
1. Remove the existing fixed foot from the end of the
Dynamics Track.
2. Loosen the thumbscrew on the Adjustable Dynam-
ics Track Foot.
3. With the leveling feet aiming away from the under-
side of the track, slide the square nut of the adjust-
able foot into the slot on the side of the track.
NOTE: The flat side of the square nut must face the
outside of the Dynamics Cart Track as shown.
4. Position the foot as desired.
5. Retighten the thumbscrew.
6. Set the leveling feet at the desired height (for
stability).
7. Tighten the stabilizer nuts against the underside of
the foot.
NOTE: When adding other accessories through
the same track slot, you must first remove the
adjustable foot.
Instruction Sheet
for the PASCO
Model ME-9470
ADJUSTABLE DYNAMICS TRACK FOOT
012-04992C
Introduction
The PASCO Model ME-9470 Adjustable Dynamics
Track Foot is designed for use as an accessory to any
PASCO Dynamics Track or Introductory Dynamics
System.
The Adjustable Dynamics Track Foot allows for a
greater range of adjustment and stability when per-
forming experiments. It also permits the user to level
the track by raising or lowering the appropriate end. It
may be used in addition to or instead of the existing
fixed foot that is supplied as standard equipment on
either the 1.2 or 2.2 meter Dynamics Tracks.
Additional Equipment Required:
• Dynamics Cart Track, 1.2 meter (ME-9435A) or 2.2
meter (ME-9458)
• Dynamics Cart, such as Model ME-9430
Additional Equipment Recommended:
• Collision Cart, such as Model ME-9454
Thumb screw
(617-002)
Square nut
(614-054)
Foot
(648-07152)
Leveling foot 2X
(614-034) Adjustment
screw 2X
(610-174)
track