PASCO WA-9607 Chladni Plates Kit - Manual (Page 2)

➤ NOTE: The Chladni Plates Kit is designed to
be used with the PASCO Wave Drivers (WA-9753
or SF-9324). The banana plug connectors attached
to the plates connect directly with the drive shaft.
➤ IMPORTANT: Always lock the drive shaft of
the SF-9324 before attaching or removing the plates.
To Use the Chladni Plates
➀ Connect the Chladni plate to the drive shaft as illus-
trated on the previous page. The banana plug mates
directly with the hole in the drive shaft.
➁
Sprinkle sand on top of the plate.
➂ Unlock the drive shaft of the Wave Driver.
➃
Connect the Wave Driver to your function generator/
amplifier (such as PASCO Models PI-9587C Digital
Function Generator or PI-9598 Student Function Gen-
erator). Vibrate the plate over a range of frequencies
from about 100 Hz up to 5 kHz. As you slowly vary
the frequency of vibration, you will discover a variety
of standing wave patterns. (Don't change the fre-
quency too fast—the resonances are very sharp and
you might miss some.) Adjust the amplitude and the
amount of sand as necessary to get clear patterns.
➄ An interesting experiment is to hold an edge of the
plate to determine the effect on the resonant frequen-
cies and patterns. You can induce asymmetric stand-
ing wave patterns in the round plate by unscrewing the
banana plug and connecting it to the off-center hole in
the plate.
➅
For further investigations, you may want to create
your own Chladni plates. We recommend you cut
them from aluminum sheets (approx. 0.035"), but you
might find it interesting to experiment with other ma-
terials.
Keeping It Quiet
At high frequencies, you’ll find that the Chladni plates
and the wave driver are LOUD. You can minimize the
noise with the optional WA-9610 Chladni Plate Cover, a
clear acrylic cover that fits over the plates and driver.
®
012 - 03283D Chladni Plates Kit
Optional WA-9610 Chladni Plate Cover
Limited Warranty
PASCO scientific warrants this product to be free from
defects in materials and workmanship for a period of one
year from the date of shipment to the customer. PASCO
will repair or replace, at its option, any part of the product
which is deemed to be defective in material or workman-
ship. This warranty does not cover damage to the product
caused by abuse or improper use. Determination of
whether a product failure is the result of a manufacturing
defect or improper use by the customer shall be made
solely by PASCO scientific. Responsibility for the return
of equipment for warranty repair belongs to the cus-
tomer. Equipment must be properly packed to prevent
damage and shipped postage or freight prepaid. (Dam-
age caused by improper packing of the equipment for
return shipment will not be covered by the warranty.)
Shipping costs for returning the equipment, after repair,
will be paid by PASCO scientific.
To Reach PASCO
For Technical Support call us at 1-800-772-8700 (toll-
free within the U.S.) or (916) 786-3800.
email: [email protected]
Tech support fax: (916) 786-3292