PASCO ME-8972 Adjustable Feet - Manual

I n s tr u c t i o n S he e t
0 1 2 - 0 9 9 9 3A
Adjustable Feet
ME-8972
800-772-8700 www.pasco.com
®
Introduction
PASCO model ME-8972 consists of two feet sets for use
with PASCO dynamics tracks. It is compatible with any
aluminum PASCO track.
Installation
Attach each feet set to the T-slot on the side of the track as
illustrated. Tighten the thumbscrew to hold the feet set in
position. Turn the feet screws to level the track; then tighten the
lock nuts to secure them.
1: Slide tab into T-slot on side of track. 2: Tighten thumbscrew to secure
feet set. 3: Turn feet screws to level track. 4: Tighten lock nuts to secure
feet screws.
For maximum stability, position the feet about 1/4 of the track
length from each end.
For Use with Older Tracks
If you have an older PASCO track (see illustration), install the
included washers to prevent the thumbscrews from “bottoming
out.”
2
1
3
4
1/4 1/4
Newer track
(No washer needed)
Older track
Lacks extra T-slot clearance.
Install washer on thumbscrew.