PASCO ME-6988A Force Platform Structures Bracket - Manual (Page 3)

M o d e l N o . M E - 6 9 8 8 A O t h e r U s e s f o r t h e B r a c k e t
3
The outermost attachment positions relative to the center are
designed for a span of a #4 I-beam and a separation of a #5
I-beam if the Brackets are mounted on a PASCO Force Platform.
However, if the Brackets are mounted on another platform, or no
platform as shown in Figure 3, then the span can be longer or
shorter than a #4 I-beam.
Please refer to the instruction manuals for the PASCO Structures
System Sets for ideas of what structures can be built and attached
to the Force Platform Structures Bracket and a Force Platform.
Examples include large bridges and a tower crane.
Other Uses for the Bracket
You can use the Force Platform Structures Bracket on a different
force-measurement platform if you have the means to attach the
Bracket to your platform.
As shown in Figure 4, it is also possible to attach a structure to
just one Force Platform Structures Bracket.
The attachment positions on the Bracket are at the same height as
the top attachment position on a “half-round” connector (part of
the ME-6990 Truss Set).
Technical Support
For assistance with any PASCO product, contact PASCO at:
For more information about the Force Platform Structures
Bracket and the latest revision of this Instruction Sheet, visit:
www.pasco.com/go?ME-6988A
Limited Warranty For a description of the product warranty, see the
PASCO catalog. Copyright The PASCO scientific 012-12312A Force
Platform Structures Bracket Instruction Sheet is copyrighted with all rights
reserved. Permission is granted to non-profit educational institutions for
reproduction of any part of this manual, providing the reproductions are
used only in their laboratories and classrooms, and are not sold for profit.
Reproduction under any other circumstances, without the written consent
of PASCO scientific, is prohibited.
Trademarks PASCO and PASCO
scientific are trademarks or registered trademarks of PASCO scientific, in
the United States and/or in other countries. All other brands, products, or
service names are or may be trademarks or service marks of, and are
used to identify, products or services of, their respective owners. For more
information visit www.pasco.com/legal.
Patents Pending The following PASCO products have patents pending:
#5
Outermost
attachment
position (5)
#5
#4
#4
Half-round
connector
#3
#3
Figure 4: Using one Force Platform Structures Bracket
Half-round
connector
Innermost
attachment
position (3)
Address: PASCO scientific
10101 Foothills Blvd.
Roseville, CA 95747-7100
Phone: 916-786-3800 (worldwide)
800-772-8700 (U.S.)
Fax: (916) 786-7565
Web: www.pasco.com
Email: [email protected]
ME-6984 Structures Hydraulics Set ME-7004 Destructible Bridge Set
ME-6987 Flat Structures Members ME-7009 Cast Beam Structures Set
ME-6989 Physics Structures Set PS-2198 Load Cell Amplifier
ME-6990 Truss Set PS-2199 Load Cell and Amplifier Set
ME-6991 Bridge Set PS-2200 100 N Load Cell
ME-6992A Adv. Structures Set PS-2201 5 N Load Cell
ME-6995 Road Bed Spares PS-2205 Dual Load Cell Amplifier