PASCO ET-8772 Energy Transfer - Hydro Accessory User Manual

Page 3

Model No. ET-8772

012-08446A

Note: The clip is spring loaded
and can turn to adjust where the
water stream hits the turbine. To
increase the water flow, cut (trim)
the nozzle end.

5. Connect the nozzle to a piece

of tubing connected to an
external water supply. (See
section below and Figure 3).

Note: Have a beaker or container
below the housing to collect water
exiting the turbine (Figure 2).

6. Run the water supply through the nozzle of the turbine and watch

the turbine spin.

Using the ET-Hydro Accessory

with the Water Reservoir

PASCO’s Water Reservoir (ME-
8594) is recommended for
holding and supplying the water
to the Hydro Accessory.

1. Connect a tube from the

bottom hose fitting of the
Water Reservoir to the nozzle
on the ET-Hydro Accessory
(Figure 3). Clamp the tube.

2. To allow water flow into the

ET-Hydro Accessory, open
the clamp to the bottom tube.
Water will run through the
nozzle and turn the impeller.

For more information on setting
up the ME-8594 Water Reservoir with the ET-Hydro Accessory, see
the instruction sheet for the Water Reservoir. For suggested
experiments with the ET-Hydro Accessory, see the ET-8771
ET-Generator manual.

Figure 2: Nozzle Clipped
in Turbine Housing

nozzle

turbine

Water

Reservoir

Plastic

tubing

Figure 3: Water Reservoir
and Generator

nozzle