PASCO ME-8744 ADJUSTABLE ANGLE ROD CLAMP - Manual

Instruction Sheet
for the PASCO
Model ME-8744
ADJUSTABLE ANGLE ROD CLAMP
012-06111A
3/96
$1.00
better
teach science
ways to
Phone (916) 786-3800 • FAX (916) 786-8905 • email: [email protected]
10101 Foothills Blvd. • P.O. Box 619011 • Roseville, CA 95678-9011 USA
®
© 1996 PASCO scientific
This instruction sheet written/edited by: Robert Morrison
Introduction
The Adjustable Angle Rod Clamp is designed to allow
users flexibility in their lab set up.
Equipment
– Adjustable Angle Rod Clamp assembly.
Additional equipment recommended:
– PASCO ME-8735 Large Rod Stand
– PASCO ME-8738 90 cm Support Rod
Assembly
To use the Adjustable Angle Rod Clamp:
➀
Attach the “fixed” rod clamp, with the locking knob
permanently affixed, to a base rod up to 1/2” (12.5
mm) in diameter. See Figure 1.
➁ Secure the rod clamp in place with the thumbscrew.
➂ Loosen the locking knob and rotate the “mobile” rod
clamp into the desired position. See Figure 2.
➃ Tighten the locking knob against the mobile rod
clamp until secure.
➄ Place additional rod or equipment in the mobile rod
clamp and secure with the thumbscrew.
ME-8735 Large Rod Stand
(not included)
Figure 1: Setting Up the ME-8744
Adjustable Angle Rod Clamp
support rod
thumbscrew
“fixed” rod
clamp
“mobile” rod clamp
locking knob
“fixed” rod clamp
ME-8744 Adjustable
Angle Rod Clamp