Pach and Company AeGIS 8000P Series Manual User Manual

Page 20

AeGIS8000P

Page 20

FIRMWARE VERSION

Must be in programming mode, see Two ways to
Log-on to programming mode: on page 13

1. Enter function code 46 then press #

V:8250 is model number 8250P
02/16/11 is firmware release date

ERASE MEMORY TO FACTORY DEFAULT

SETTING

1= Erase

0= Cancel

Must be in programming mode, see Two ways to
Log-on to programming mode: on page 13

1. Enter function code 50 then press #

2. Press 1= erase or 0= cancel then press #

ENABLE NO PHONE BILL

Not applicable

MODEM PROTOCOL

0= Bell

1= V22

Default is V22

Must be in programming mode, see Two ways to
Log-on to programming mode: on page 13

1. Enter function code 70 then press #

2. Press 1= V22 or 0= BELL then press #

ENABLE MODEM

0= Disable

1= Enable

Default is Enable

Must be in programming mode, see Two ways to
Log-on to programming mode: on page 13

1. Enter function code 71 then press #

WARNING: MASKING THE MASTER CODE

WILL DISABLE THE RETRIEVAL BUTTON. THERE
ISN’T A WAY TO RECOVER THE MASTER CODE.
PACH AND COMPANY WILL NOT COVER THE
WARRANTY IF THE MASTER CODE HAS BEEN
FORGOTTEN.

IF YOU ARE THE INSTALLER DO NOT MASK THE
MASTER CODE.

V:8250 02/16/11

1 to Confirm: _

WARNING: SYSTEM WILL BE RESTORED TO

FACTORY DEFAULT, ALL DATABASES WILL BE
ERASED, NO WAY TO RECOVER.

1_V22,0_BELL:1