Pach and Company AeGIS 8000P Series Manual - Manual (Page 15)

AeGIS8000P Page 15
3. Enter the person name up to 16-characters.
Press # after entering each letter, see
(Keypad Function and Layout page 14).
Press ## after entering last letter. The screen
will show
4. Enter telephone number up to 11 digit, then
press #,
5. Enter 4-digit access code then press #.
Repeat step 1 to program another tenant.
02
EDITING TENANT DIRECTORY
Must be in programming mode, see Two ways to
Log-on to programming mode: on page 13
1. Enter function code 02 then press #
2. Enter 2, 3 or 4 digit directory to be edited
3. Enter the person name up to 16-digit. Press #
after entering each letter, see ( Keypad
Function and Layout page 14). Press ##
after entering last letter. The screen will show
4. Enter telephone number up to 11 digit, then
press #,
5. Enter 4-digit access code then press #.
Enter the Name
_ _ _ _ _ _ _ _ _ _ _ _ _
PH#:_ _ _ _ _ _ _ _ _ _ _
Access Code:_ _ _ _
Enter Dir: _ _ _
Enter the Name
_ _ _ _ _ _ _ _ _ _ _ _ _
PH#:_ _ _ _ _ _ _ _ _ _ _
Access Code:_ _ _ _
NOTE: PRESS # TO KEEP EXISTING
INFORMATION
NOTE: DIRECTORY MUST BE UNIQUE FOR
EACH TENANT OTHERWISE THE DISPLAY
WILL SHOW
DIR # is used !
NOTE: IF DIRECTORY DOES NOT EXIST, THE
DISPLAY WILL SHOW
DIR not exist !
WARNING: IF THE DIRECTORY IS
USED TO PROGRAM THE 4‐DIGIT ACCESS
CODE OR TELEPHONE NUMBER
WITHOUT
NAME , THEN YOU MUST KNOW THE
DIRECTORY CODE TO DELETE THE 4‐DIGIT
ACCESS CODE OR PHONE NUMBER. IF THE
DIRECTORY IS FORGOTTEN, YOU MUST
ERASE THE SYSTEM TO FACTORY DEFAULT.