Diamond Products WSE2226 - Manual (Page 9)

TYROLIT Hydrostress AG
Page 9
Starting the control unit WSE2226
CAUTION
The control unit WSE2226 can be damaged if it slips or overturns!
X Make sure that the control unit WSE2226 stands horizontally (handle at top).
9 Control unit WSE2226 is connected to the mains and the water supply.
9 The sawing machine is connected to the control unit WSE2226.
9 The remote controller EMERGENCY STOP has been deactivated.
9 The control unit WSE2226 is not exposed to direct sunlight.
Starting the control unit WSE2226
X Move the controls shown below on the remote controller to the 0 position.
Feed potentiometer (6)
Starter switch (5)
Feed joy stick (10)
Main motor On/Off (7)
X Switch on the control unit WSE2226 using the main switch (11).
X Switch on the radio remote controller using the starter switch (5).
– Warning lights (radio and battery) at first show red
– An audible signal sounds simultaneously
– Indicators flash coloured
– Second audible signal sounds
– Indicators show coloured
– Warning light flashes green
X Press the pulse switch (4) on the radio remote controller briefly to the ON-position.
All indicator lights except the warning light and the group alarm on the radio remote con-
troller go off.
X Press the reset button (12) on the control unit.
X Press the remote control pulse switch (4) briefly in the ON-position.
The the control unit 'ready' lights show green.
X Open the water valve on the system supply line.
X Press the Water On/Off switch (2) on the remote control unit to I.
– Water flows from the cutting tool
X Press the main motor On/Off switch (7) on the remote controller to position I.
– The electric motor starts when the main motor potentiometer is in the max. position.
X The control unit WSE2226 has started up and is ready for operation.
4.2