Diamond Products WSE2226 - Manual (Page 15)

TYROLIT Hydrostress AG
Page 15
Power and error displays on the control unit
Symbol Response Possible cause Action
Lights up red After the first 100 operating
hours, then after every 200 op-
erating hours. Carried out only by TYROLIT Hydrostress AG
or an authorised representative
Lights up red Fault:
- current overload
- short circuit
- earth fault Main motor
- defective feed motor The control unit will not start.
X Check network connection.
X Check cable.
X Replace feed motors.
X Contact TYROLIT Hydrostress AG customer service.
Lights up red Defective
- main contactor
- brake resistance
- over current Motor
- CAN fault
- group fault The control unit will not start.
X Contact TYROLIT Hydrostress AG customer service.
X Check network connection.
Lights up red Over heated
- cooling element
- control unit
- main motor The control unit will not start.
X Check cooling. Wait until it can be restarted. Before starting
press the reset button.
(Water cooling see page 20)
X Avoid direct contact with sun light.
Lights up red Phase missing The drive unit will not start or switches off during operation.
X Check the mains fuse in the distribution box and switch it on
if necessary.
X Have the site power supply checked.
X Have the extension cables, plugs and sockets
checked for faults.
Lights up red The EMERGENCY STOP has been
activated
- CAN fault X Deactivate the EMERGENCY STOP.
X Contact TYROLIT Hydrostress AG customer service.
Lights up red Feed potentiometer not in zero
position
The control unit will not start.
X Set the feed potentiometer to 0.