Diamond Products WSE2226 - Manual (Page 16)

TYROLIT Hydrostress AG
Page 16
Power and error displays on the remote controller
Symbol Response Possible cause Action
Flashes red Rechargeable battery voltage
too low X Recharge rechargeable battery.
Flashes rapidly
green No radio connection
The EMERGENCY STOP has been
activated X Switch on the control unit.
X Defective receiver.
X No receiver matched connection, see page 5.
No light shows No water flow The control unit will not start, motor does not run.
X Press the cooling water button. (LED shows blue).
Lights up red
or flashes • Group alarm on the control
unit
• When the pulse switch control
unit is operated, the main mo-
tor On/Off switch is in the po-
sition On
X Observe control unit fault indicators.
X Press the control unit reset button.
Lights up green The motor is ready to start
No light shows Contactor not ready X Operate control unit pulse switch.
Shows the current power range
Ideally: At the third, orange coloured diode (In iron fourth, red diode).