Detroit Radiant Products Company SV Series - Manual (Page 33)

4.0 Operation
Tube Heater General Manual
33
4.0 Operation
WARNING
!
Refer to the Series Insert Manual for any specific directions (e.g., single stage, two stage operation,
relight after a failure, etc.).
LIGHTING PROCEDURES:
Verify that service lid is secured.
2 Open (turn on) gas supply to the heater.
3 Close (turn on) electrical circuit (typically thermostat).
4 If the heater fails to light, turn off gas, open electrical circuit (set thermostat to lowest setting or to off).
Wait five (5) minutes before repeating above steps.
SHUTDOWN PROCEDURES:
Open (turn off) electrical circuit.
2 Close (turn off) gas supply to the heater.
3 Wait five (5) minutes before relighting heater.
This heater is not equipped with a pilot ignition system.
Do not attempt to light the system manually.
1
1