Tongue (pull type), Axle assembly, Tongue (pull type) -6 axle assembly -6 – Alamo 284 User Manual

Page 46: Assembly, Assembl y

Text mode
Original mode

ASSEMBLY

260/272/284 01/11

Assembly Section 3-6

ASSEMBL

TONGUE (Pull Type)

Insert tongue lugs (4) between mainframe uprights and retain using special pin (16). Insert retaining clip (17) to
retain pin. Be sure to install bushing (19) on each side to eliminate side movement. Figure Asm-R-0405

AXLE ASSEMBLY

Attach rear axle (1) to the lugs on the rear of the mainframe using 3/4 x 3 (8) bolts, bushings (7), flatwashers
(4) and locknuts (6). Tighten all bolts. Attach level lift rod assemblies to axle (1) Figure Asm-R-0406 and
tongue (1) Figure Asm-R-0405 using clevis pin (15), flatwashers (31) and cotter pin (38). NOTE: The
adjusting nuts on control rods should be to rear of machine. Figure Asm-R-0406

This manual is related to the following products:

260 272