Key operation points, Operating noise level/sound pressure, Warranty information – Alamo 284 User Manual
Page 38: Introduction
INTRODUCTION
260/272/284 01/11
Introduction Section 2-4
© 2011 Alamo Group Inc.
INTRODUCTION
KEY OPERATION POINTS
•
Cutting performance and distribution are best when cutter is level from side to side and front to rear.
•
In extra heavy material, rear chains will allow better discharge and better distribution than solid rear bands.
•
Never operate the Mower below full PTO speed of 540 or 1000 rpm.
•
Corn should be cut at 5 to 6 mph. If full PTO rpm cannot be maintained, use one lower gear.
Operating Noise Level/Sound Pressure
The sound levels at the operator's ear from the attached machine (rotary cutter) are at least 10 dB(A) below the
levels from typical Agricultural tractors used to power and transport this machine. Therefore, the Noise
emission values given by the OEM of the Agricultural tractor used to power and transport this machine would
be valid when this machine is attached to and operated by that Agricultural tractor in all OEM recommended
applications.
Warranty information
In addition to the standard Limited Warranty shown on the facing page, Rhino also provides:
1. A FIVE-YEAR (60 months) LIMITED WARRANTY* on GEARBOX components provided they have been
properly maintained† and have not been subjected to abuse or mis-use except as limited below.
* WARRANTY LIMITATIONS - GEARBOX
A. Warranty is ONE-YEAR (12 MONTHS) for Seals (After one year, seals are considered to be WEARING
PARTS and replacement is the users' responsibility.)
B. Users' Gearboxes may be rebuilt by Rhino or replaced by new or rebuilt Gearboxes at the option of Rhino.
2. ONE-YEAR (12 months) LIMITED WARRANTY** on the DRIVELINE components provided they have been
properly maintained† and have not been subjected to abuse or mis-use.
* *WARRANTY LIMITATIONS - DRIVELINE
A. Warranty is ONE-YEAR (12 MONTHS) for DRIVELINE SHIELDS except that evidence of wear from contact
with other parts on the shield voids this warranty.
B. Shield Bearings are wearing parts and are not warrantable.
C. Slip-Clutch Disks are wearing parts and are not warrantable. Evidence of "burning up" Slip Clutch Plates
due to improper adjustment will void warranty on Slip Clutch Parts.