Multichannel Systems Roboinject Manual - Manual (Page 60)

Roboinject Manual
56
Enable the check box "Test Injection" if you want to use this feature. Write a comment
in the "Comment" text box.
Click "OK" if you finished the settings of the sample, "Clear" if you want to restart with
default values and "Cancel" if you want to go back to the main window without changes.
Repeat the steps above until all samples you want to inject are defined.
Adjusting the Injection Parameters for each Well separate
It is possible to adjust the settings for the injection for each single well separate.
Click with the right mouse button onto a well in the virtual well plate, and the following
dialog appears. Now you can adjust the injection parameters for this specific well.
If the oocyte in the specific well should be injected with different samples, you can adjust
the injection parameters for each sample separately in the respective "Sample" tabs.