Multichannel Systems Roboinject Manual - Manual (Page 22)

Roboinject Manual
18
Click "New" in "File" menu. The following "Plate Info" dialog opens.
Please give an appropriate file name in "Plate ID". The type of the well plate can be defined
from the "Plate Type" drop down menu. If you want to set the selected plate type as default,
please enable the check box "Set As Default". You can type in notes concerning the actual
experiment into the "Comment" text box. All information will be stored in the plate info (*.rpf)
file, and displayed in the report sheet.
If you want that the plate ID is automatically counted up when creating a new file, please enable
the check box “Auto increment plate ID” in “General” tab of the “Options” dialog in main menu
“Settings”.
Click "OK" to enter additional dialogs, or to start the injection.
If you want to inject the same plate again or review previously injected cells, open the appropriate
well plate file.