Multichannel Systems LTP-Director Manual - Manual (Page 66)

LTP-Director Manual
62
6.2
Analyzing an Experiment in Analysis Mode
6.2.1 Data Display Analysis Mode
On the bottom left corner of your screen, you can toggle between "Raw Data" and "Analysis"
mode.
The design of the main window of the Analysis Mode of LTP-Analyzer is similar to that known
from the measurement mode of LTP-Director: On the left side, there is the blue control window,
besides the data display. The data display is separated into smaller windows. You can observe the
data traces of up to four - in raw data mode selected - electrodes, and you see parallel the online
analysis of the selected parameter of these electrodes.
Hint: For information about the multiple display features like scrolling and zooming, please read
chapter "General LTP-Director Software Features".