Micromod MOD: Modcell 2050R 2050FZ0, QS-1300/1400 to 2050R Conversion Accessory - Manual (Page 8)

92902-88
2050F Conversion Instructions
MODCELL 2050 to Quick-Scan 1340R &1350R Series
Direct Connect Cable Option
Termination Connections to MODCELL 2050
This instruction sheet provides termination identification and locations for wiring the Quick-Scan Direct
Connect Cable to a MODCELL 2050 when replacing a 1340R/1350R Series instrument. Little or no
wiring changes need to be made on the Quick-Scan 1300 terminal block. Please read the application
notes, limitations and configuration specific instructions located at the bottom and back of this page
before proceeding. Other signals from or to MODCELL 2050 may be used via spare wires in the cable.
Special Note
MODCELL 2050 does not support float and lock command inputs. However, MODCELL 2050 does
accept a remote set-point input which may be remotely ramped. MODCELL 2050 also has an integral ten
segment ramp/soap set-point profile generator. As an alternative to the float and lock commands, the
ramp rate and set-points may be configured into the controller and initiated via a digital input. The profile
may be down loaded from a host via the RS-485 MODBUS serial communications as well. See IB-
23C650 for additional details of the ramp/soak profile program.
WARNING
Avoid electrical shock. AC power wiring must not be
connected at the distribution panel (ac source) until all
wiring procedures are completed.
MODCELL 2050 Termination Block
Not Used
Org/Blk
Black/wht/Red
Blk
Blu
Blk/Red
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
L2
L1
29
30
31
32
33
34
35
36
37
38
39
40
16
17
25
41
42
43
44
45
46
47
48
49
Grn
Wht
Blk/Wht
Red
Wht
Blk
Grn
Power Cord
Process Input [see note 2]
Output
(.25 - 1.25 Vdc)
(4 - 20 mA)
Remote Set-point Input
(.25 - 1.25 Vdc)
Ramped Set-point Monitor
(4 - 20 mA) [see note 1]
(AC or DC)
8