Micromod MOD: Modcell 2050R 2050FZ0, QS-1300/1400 to 2050R Conversion Accessory - Manual (Page 3)

92902-88
2050F Conversion Instructions
Conversion Instructions for QS-1300
Conversion Accessory to MODCELL 2050
when using the Direct Connect Cable Option
The Direct Connect Cable is found in the 2050FZ00001A Conversion Accessory kit only. This provides
the quickest conversion change out while retaining the original QS-1300 instrument cable. Table 2
provides termination identification for wiring the Direct Connect Cable to the MODCELL 2050.
It is best to install the Direct Connect Cable to the MODCELL 2050 at the bench prior to installation of the
instrument at the control panel site. Kit hardware mounting and configuration should be concluded at that
time as well. If this is accomplished, front of panel instrument change out will only take a few minutes.
Use Table 2 as a reference when installing the Direct Connect Cable option for the Quick-Scan
conversion accessory as detailed in the following pages.
Table 2. I/O Wiring Configuration for Direct Connect Cable
Quick-Scan 1300 Series Connections MODCELL 2050
Terminal Block # Extended Cable Color J101 Connections Direct Connect Cable Colors Term. No.
1* Black B (ac), C (dc) Black L1
2* Green A Green Stud
3* White D White L2
4 Blue M Blue 15
5 Black N N/C
6 Black F Black 11
7 Red E Red 14
8 White J White 10
9 Black H Black/White 9
10 Brown P N/C
11 Black R N/C
12 Yellow T Orange/Black 3
13 Black S Black/White/Red 2
14 White 16 N/C
15 Red 15 N/C
16 Green K Green 7
17 Black L Black/Red 4
18 Green 3 N/C
33 White 4 N/C
19 Yellow 11 Orange/Red 45
20 Red 12 White/Black 46
21 Orange 7 Orange 44
22 Red 8 N/C
23 Brown 10 Green/Black N/A
24 Red 9 Red/White 48
25 Blue 13 Blue/White 49
26 Red 14 Red/Black/White 47
27 Blue 5 Blue/Red N/A
28 Green 6 Green/White N/A
29 Black U N/C
30 Orange V N/C
31 Red 17 N/C
32 Green 18 N/C
34 Unused
35 Unused
36 Unused
37 Unused
* Positions 1,2 & 3 are wires located in the 3-conductor power cable.
3