Meriam M2110L SMART LEVEL GAUGE - Manual (Page 29)

9R143 Dated 3/2011
27
OUTLINE DIMENSIONS
PANEL MOUNTING
1. Make a ¼ DIN panel cutout per drawing.
2. Remove the two 6-32 socket head screws in the
grooves at the rear of the gauge.
3. Slide the panel mount jacks out of the groove.
4. Insert the gauge through the front of the panel.
5. From the rear, insert the panel mount jacks in the
grooves on the side of the gauge, and slide them
firmly against the panel.
6. Replace the two 6-32 socket head screws in the
grooves behind the panel mount jacks.
7. Tighten the panel mount jack against the panel
with the two socket head screws.
8. Refer to the note on page 25 when making
pressure connections.
3.60" +/- 0.010
(92)
( ) DIMENSIONS IN MILLIMETERS
3.60" +/- 0.010
(92)
PANEL MOUNTING CUTOUT DIMENSIONS