Max Machinery 220, 221 and 222 FLOW METERS - Manual (Page 5)

220-000-350 © 2004 Max Machinery, Inc. Page 5
Troubleshooting, Maintenance
T ROUBLESHOOTING :
Problem Cause Solution
Material will not pass Solid particle in Disassemble and remove
through flow meter. gears or hardened particle or clean.
material.
Material flows through Solid particle in Disassemble and remove
flow meter, but transmitter gears. particle.
does not run and pressure
drop is high.
Material flows through Frozen or hard Warm flow meter or
flow meter. Meter sounds material in magnet disassemble and clean.
like it runs but trans- shield.
mitter does not rotate.
Flow meter operates, but Transmitter drive Straighten shaft and
output is erratic. magnet drags on check end clearance.
meter body.
Discontinued