beautypg.com

Figure d with stock starter, Figure e with mallory comp, Starter – Mallory Ignition Mallory COMP STARTER User Manual

Page 3

background image

3

Move the starter cable from the current position on the remote solenoid to the

opposite side (same side as battery cable).

Run a 10 gauge or larger wire from the remote solenoid terminal (where the

starter cable used to be) to the small terminal on the Mallory starter solenoid.

Step 7

Vehicles with remote Solenoid (includes most Ford/AMC):

NOTE: Mallory does not recommend using a jumper wire on the

solenoid. Installing a jumper wire on a permanent magnet motor can

result in current feedback, which can cause the pinion to remain

engaged with the flywheel after the engine starts. This will result in

eventual starter failure.

REMOTE

SOLENOID

BATTERY

—

BATTERY CABLE

STARTER CABLE

——

10 GAUGE OR LARGER

2 GAUGE OR LARGER

FIGURE D

WITH STOCK STARTER

STOCK STARTER

REMOTE

SOLENOID

BATTERY

—

——

STARTER CABLE

BATTERY CABLE

FIGURE E

WITH MALLORY COMP

®

STARTER