Luminex xPONENT 4.2 for FLEXMAP 3D - Manual (Page 7)

Results - Analyze previously acquired batches; view current and saved reports
Protocols - Displays protocols, Stds & Ctrls, and Lot information.
Maintenance - Calibrate, verify, and maintain the application
Admin - Perform administrative tasks
Log Off - Log out of software
Help - Access help file
System Monitor
The System Monitor is displayed at the bottom of all xPONENT ® windows. It displays the
physical state of the Luminex ® system. Values are reported directly from the Luminex ®
system.
1 System Status button 2 Connection Status 3 Check Cal/Ver Ok
4 Command Display 5 Progress Bar and buttons 6 Stop button
7 Pause button 8 Eject button 9 Delta Cal Temp Status
10 Sheath Pressure 11 XY Status 12 Laser Status
13 Region Event Status 14 Total Events Status 15 Warm Up button
3