Luminex 200 Installation Guide - Manual (Page 44)

Install the Luminex XYP Instrument Heater Block
Use the Luminex XYP instrument heater block as required by your assay kit instructions. This
is an optional step. When not in use, store the heater block in the bracket inside the left
access door of the Luminex 200 analyzer.
To install the Luminex XYP instrument heater block:
1. Eject the plate holder.
2. Insert the Luminex XYP instrument heater block on the plate holder.
3. Retract the plate holder.
4. Turn the heater on and set the temperature. Refer to the applicable Luminex software
manual.
NOTE: For new system installations, perform the preliminary commands
listed in the Prepare System for First Use section before running
samples.
In Vitro Diagnostic Use Luminex 200 System Setup
33