Magnum Venus Plastech TALON Gun Internal Mix - Manual (Page 24)

Talon Internal Mix Gun Manual
Rev. 10/2013 Page | 24
Mix Housing Options:

Standard Mix Housing (5104-20-1)
– Use with all turbulent mixers and most
applications.

FIT Mix Housing (VPG-1001)
– Use with FIT style spray tips. Uses Mixer VPG-
1003.

FIT Low Flow Mix Housing (VPG-1001-1/4)
– replacement Mixer TRT-1018-1/4

Ratio Block
– Pail Dispenser Mix Housing (58735-1) – separates material streams.
Distribution Ring Selection:
There are three different distribution rings and they are as follows:

Standard Distribution Ring 5104-17-1 (58607-1)
– Used for most applications
where outputs are not critical.

Filled Resin Distribution Ring 5104-18-1 (58701-1)
– Used in application where
the resin is filled above 20 percent. Use with high filler loads and high outputs.

Critical Mix Distribution Ring 5104-19-1 (58703-1) – Use in low output
application, where it is important to restrict flow.
Turbulent Mixer Selection:
There are two different turbulent mixers, in two different materials.

Standard Turbulent Mixer 5107-27-3 – Use for most applications where outputs
are not critical. Use with chopper and saturator applications.

Glass Filled Special Turbulent Mixer 5107-27-4 – Use with abrasive materials
and filled resin applications where durability is required.

Critical Mix Turbulent Mixer 5107-27-2
– Use for low output applications such as
gel coat. In low flow application the critical mix turbulent mixer will work best.

Glass Filled Critical Mix Turbulent Mixer 5107-27-5 – Use in low flow applications
where the material is abrasive and durability is required.