Impulse SIO-104+16.485 (3562) - Manual (Page 10)

© Sealevel Systems, Inc. - 8 - SIO-104+16.485 User Manual
Physical Installation
Extreme care should be taken when installing the SIO-104+16.485 to avoid causing
damage to the connectors. After the adapter is installed, connect your I/O cable to
the 40-pin header located at J1. Refer to Hardware Setup for information on setting
the address and jumper options before inserting the SIO-104+16.485 onto the stack.
Do not install the Adapter in the machine until the software has been fully
installed.
1. Turn off power. Disconnect the power cord.
2. Gently insert the SIO-104+16.485 connector noting proper key orientation of the
expansion connector on a PC/104 compatible card. The SIO-104+16.485 adapter
is keyed per the current PC/104 Specification. This will aid in preventing the
adapter from being inserted incorrectly.
3. Mounting hardware (nylon stand-offs and screws) is provided to ensure a good
mechanical connection. Retain any mounting hardware not used to allow for
future expansion.
4. Replace the cover.
5. Connect the power cord and power up the machine.
The SIO-104+16.485 is now ready for use.