Controlled Products Systems Group 9100-080 - Manual (Page 30)

2.3 Loop Detector Wiring
Loops and loop detectors must be installed with this gate operator to prevent the gate from
accidentally closing on vehicles that may be in the path of the gate.
Detail A
Detail A
TB 1
From inside
Reverse loop
From outside
Reverse loop
Reverse
Loop
Exit
Loop
Timer
Reverse
Sensitivity
Counter
LEDs
Relay Contact
Power
1 2
3
4 5
6
7
8
ON
1 2
3
4 5
6
7
8
Reverse
Reverse
Exit
DOORKING, INC., INGLEWOOD, CA 90301
Title:
Date: Rev. Dwg. No.
DoorKing
Loop Detector
DoorKing
Loop Detector
Loops and loop detectors MUST be installed with this gate
operator to help prevent the gate from accidentally closing on
vehicular traffic.
Loop detector wiring is shown for DoorKing plug-in loop
detectors only. If other loop detectors are used, refer to the
installation instructions supplied with those detectors for
wiring instructions.
If other detectors are used, use a separate power supply to
power these detectors.
Loop layout shown is for a typical slide gate application with
two-way traffic, or one-way exit only traffic.
Reverse loops are wired in series. See detail A.
Refer to the Loop Information Manual (available from
www.dkaccess.com) for more information on loops and loop
detectors.
5/07 A 4602-LOOP-1
Model 9100 and 9150
Loop Detector Wiring
Figure 26
Page 30 9100-065-D-5-07