Controlled Products Systems Group 1601-080 - Manual (Page 13)

1601-065-G-6-12 11
1. Com
Com
3. 24 Volt
2. Relay
DoorKing Access Control System
(Model 1833, 1835, 1837 or 1838)
tracker system can be connected.
This system can keep track of gate
operator cycle count, shorted inputs,
loop detector problems, any forced
entry attempts, if the gate has struck
anything during the open or close
cycle, power interruptions, etc.
For more detailed information refer
to the Tracker Installation and Wiring
Manual, DoorKing P/N 2351-010.
Gate Tracker
(Quad Box Shown)
Contact Sensor (Reversing Edge)
See page 29
3-Wire Radio Receiver
Up-Inputs
Down-Inputs
Non-Contact Sensor (Photo Sensors)
REVERSE
SENSITIVITY
TIME
DELAY
POWER
1 ON
2
3
4
5
6
7
8
1 ON
2
3
4
5
6
7
8
NC NO
UP
LOOP
DOWN
LOOP
1 2 3 4 5 6 7 8 9 10 11 12 13 14
1601
Terminal 6 required only if the
tracker board will activate the
gate operator. Refer to the
manual 2351-065 for detailed
information.
Manual Gate Control Toggle
P/N 1200-017
Up toggle position: User toggles switch up to hold gate open.
Center toggle position: Is neutral for normal operation.
Down toggle position: User momentarily toggles switch down to open gate.
User MUST make sure gate area IS CLEAR
before manually operating gate arm.
21” Typical Beam Height.
27.5” Max. Beam Height.
2.5 Control Wiring for Single/Primary Operator
OPEN
HOLD OPEN
WARNING
Contact and Non-Contact Sensors Note:
Helps minimizes the potential of the arm
lowering on vehicular or other traffic that
loops cannot sense.
Gate Operator
Data Terminal
Coax Antenna Kit
P/N 1514-073
Antenna mounted outside
operator housing.