Controlled Products Systems Group 1520-080 - Manual (Page 7)

Page 7
• Prior to starting the installation, become familiar with the instructions, illustrations and wiring
diagrams in this manual.
• Never mount this device to a moving gate or gate panel, or next to a gate that causes
vibration to the fence, such as a spring-loaded pedestrian gate. Continuous vibration from
moving or slamming gates can cause damage to the unit in time.
• If this system is used to activate an automatic vehicular gate operator, it must be
mounted in such a way that the user cannot come into contact with the gate or the
gate operator when the device is used. We recommend that the unit be installed a
minimum of 10 feet away from the gate and gate operator.
• Always disconnect power when performing service on the system.
• If the unit is mounted outdoors, be sure that the wiring to the unit is designed for direct under-
ground burial, even if the wire is run inside a conduit.
• Surge suppression is recommended on the low voltage input power line.
• Instruct the end user on the safe and proper operation of this device.
• Instruct the end user to read and follow these instructions. Instruct the end user to
never let children play with or operate any access control device. This Owner’s
Manual is the property of the end user and must be left with them when installation is
complete.
IMPORTANT INFORMATION