Controlled Products Systems Group 1520-080 - Manual (Page 16)

Page 16
2.4 Time Zones
There are two types of time zones that can be used with the 1520 controller; CARD time zones and
HOLD time zones. CARD time zones are applied to the individual card codes programmed into the
system and HOLD time zones activate and deactivate the relay in the 1520 at predetermined times.
There are six CARD time zones. These are referenced as time zones 0 through 5. Only time zones
2 through 5 are programmable. Time zone 0 will always deny a card entry and time zone 1 will
always grant a card entry. The four HOLD time zones, 6 through 9, are user programmable.
Time zone beginning and ending times must be in the four-digit 12-hour format (hr/min). For
example, 8:30 is entered as 0830; 11:45 is entered as 1145. You need not be concerned with AM or
PM when entering the beginning and ending times.
You need to program what days of the week the time zone is applied. The days of the week is
entered as a seven digits; Sunday = 1, Saturday = 7. If you want to skip a day, enter # for the days to
be skipped. For example, if a time zone is to be applied Monday through Friday only, you need to
enter: 2 3 4 5 6 # # in the programming sequence. If the time zone is to be applied on the weekend
only (Saturday, Sunday), you would enter 1 7 # # # # # in the programming sequence.
2.4.1 Programming Card Time Zones
1. Press *38 and enter the four-digit master code (short beep).
2. Enter a single digit time zone number _ (2 – 5) then press * (short beep).
3. Enter the time zone start time _ _ _ _ (hr/min) then press * (short beep).
4. Enter 0 for AM or 1 for PM then press * (short beep).
5. Enter the time zone end time _ _ _ _ (hr/min) then press * (short beep).
6. Enter 0 for AM or 1 for PM then press * (short beep).
7. Enter the days of the week that the time zone is applied _ _ _ _ _ _ _ (1 – 7, #) then
press * (short beep).
8. Repeat steps 2-7 to enter additional time zones.
9. Press 0# together to end the programming step (long beep).
2.4.2 Programming Hold Time Zones
1. Press *38 and enter the four-digit master code (short beep).
2. Enter a single digit time zone number _ (6 – 9) then press * (short beep).
3. Enter the time zone start time _ _ _ _ (hr/min) then press * (short beep).
4. Enter 0 for AM or 1 for PM then press * (short beep).
5. Enter the time zone end time _ _ _ _ (hr/min) then press * (short beep).
6. Enter 0 for AM or 1 for PM then press * (short beep).
7. Enter the days of the week that the time zone is applied _ _ _ _ _ _ _ (1 – 7, #) then
press * (short beep).
8. Repeat steps 2-7 to enter additional time zones.
9. Press 0# together to end the programming step (long beep).
2.4.3 Erase Time Zones
1. Press *39 and enter the four-digit master code (short beep).
2. Enter the time zone number to be erased _ (2 – 9) then press * (short beep).
3. Repeat step 2 to erase additional time zones.
4. Press 0# together to end the programming step (long beep).