Controlled Products Systems Group 1520-080 - Manual (Page 20)

Page 20
The table list the many different print functions that the 1520 controller can perform. After each
function is complete, a long beep will sound.
3.1 Selective Transaction Print
In addition to the above print functions, the following programming sequence will print transactions for
a selected month and a selected day of the month.
1. Press *34 and then enter the four-digit master code (short beep).
2. Enter the month _ _ (01 = January, 12 = December) and then press * (short Beep).
3. Enter the day of the month _ _ and then press *.
4. The printer will start to print the transactions stored for the selected month and day.
When complete, a long beep will sound.
SECTION 3 – PRINT FUNCTIONS
Keypad Entry Function
*22 + master code Prints all card codes currently stored in the system memory.
*06 + master code Prints all facility codes currently stored in the system memory.
*40 + master code Prints time zone information currently stored in the system memory.
*32 + master code Prints the current date and time.
*02 + master code Prints the programmed relay strike time.
*27 + master code Prints the status of timed anti-pass back (On or Off).
*55 + master code Prints the size of the memory chip currently installed in the controller
(125, 500 or 1000).
*37 + master code Prints the transactions currently stored in the transaction buffer.
*31 + master code Prints the status of the real time print mode (On or Off).