Multiple tib/tsam system example, Ultiple, Tib/tsam s – CTI Products TIB TSAM Interface User Manual
Page 22: Ystem, Xample, 2 multiple tib/tsam system example

TIB Hardware Reference
System Examples
CTI Products, Inc.
68-10911-100
17
voted and that transmitter 8 is active. Both of these states will be shown on the
operator’s PC.
To force the TSAM to steer to transmitter 1, the operator will generate a FORCE
VOTE for receiver 1. The TIB will receive this FORCE VOTE for receiver 1 and
setup the Tx Select lines for transmitter 1 and the Force Select line. When the
TIB activates the Force Select line to the TSAM, the TSAM will immediately
steer to transmitter 1. The FORCE VOTE for receiver 1 will also cause the CIB
to generate a FORCE VOTE command to the comparator.
9.2
Multiple TIB/TSAM System Example
Figure 9 shows an example system that has 16 receivers and transmitters on the
same communication channel. Therefore, 2 TIBs and 2 TSAMs are required
because each only supports 8 transmitters. In Figure 9, the console audio
connections were omitted to keep the diagram simple. Normally the console
audio paths would be connected the same as shown in Figure 8.
CA-80120-100
COM 2
COM 1
COMPARATOR
OUT
FORCE SELECT
TX SELECT
OUT
TX SELECT
1
COMPARATOR
HIB
P/S
OUT
T
IN
OUT
T
IN
IN
IN
OUT
IN
CIB 1
CIB 2
TIB 2
TIB 1
TSAM 1
P103
EXPANSION
BUS
2
VOTE LINES
VOTE LINES
FORCE
SELECT
MASTER
TSAM 2
EXPANSION
TX1
RX1
P/S
RX8
TX8
RX9
TX9
RX16
TX16
LOCAL PC
Figure 9 - Multiple TIB/TSAM Example
For the system shown in the figure, note the following:
• Comparator 1 and TSAM 1 control receivers 1 through 8 and
transmitters 1 through 8 respectively.
• Comparator 2 and TSAM 2 control receivers 9 through 16 and
transmitters 9 through 16 respectively.