CTI Products EXB-232 Asynchronous Serial System Extender - Manual (Page 26)

68-11089-115
22
Appendix C EXB Mounting Options
Wall mount and EIA 19” rack mount kits are available as options for the EXB from CTI
Products, Inc. The wall mount kit includes brackets to allow a single EXB module to be
mounted to any flat surface. The rack mount kit includes an adapter allowing up to three EXB
modules to be mounted in a single rack unit height.
Wall Mount Option
The wall mount option allows an EXB module to be mounted to any flat surface. The EXB
module has four screw holes on the bottom. Simply attach the two mounting plates to the bottom
of the module using the four flat-head screws provided with the wall mount kit. This assembly is
then attached to the flat surface with user-provided fasteners. Figure 12 shows an exploded view
of the wall mount installation.
CA-80112-100
1 2 3 4 5 6 7 8 ON
OPTION A
DC IN
ERR
ACT PWR
RSVC CSVC
AUDIO LINE CD OH
RESET
CMD
NCB NETWORK COMBINER
NETWORK
Figure 10 EXB Module Wall Mounting
CAUTION
Be sure to use the flat head screws provided with the wall mount kit. If you are not using the wall
mount kit from CTI Products, Inc., make sure that the screws do not protrude into the enclosure
more than 0.125 inches from the bottom surface of the module.
Using a longer screw that touches the PC board inside the module may damage the module. Doing
so will void the unit’s warranty.