Coast G30 - Manual

G30 Instructions:
Battery Installation
Turn the end cap in a counter-clockwise direction to remove the cap.
Place two AA batteries into the light, positive end of the battery first.
Replace the tail cap and turn it clockwise to tighten it until it is fully closed.
On/Off Operation
The G30 has a rear switch on the tail cap.
To turn on the light, press the switch fully until it “clicks.”
To turn off the light, press the switch fully until it “clicks.”
The light can also be operated in “momentary” mode. Momentary mode is activated by
partially depressing the on/off switch (less pressure than required for a full click).
Pure Beam Focusing Optic
This flashlight is equipped with COAST’s Pure Beam™ Focusing Optic that allows the user to
choose between a broad flood beam and a focused Bulls-Eye Spot™ beam for long distance
illumination.
To adjust the beam into the Bulls-Eye Spot™ mode, turn the front bezel of the light clockwise.
To adjust the beam into the broad, flood light mode, turn the front bezel of the light counter-
clockwise.