Coast HP17TAC - Manual

HP17 Instructions:
Battery Installation
Turn the end cap in a counter-clockwise direction to remove the cap.
Place three D batteries into the light, positive end of the battery first.
Replace the tail cap and turn it clockwise to tighten it until it is fully closed.
Quick Cycle Switch Operation
This flashlight is equipped with COAST’s Quick Cycle Switch™, featuring high, and low beams.
To activate the high beam from the off position, press the on/off switch until it clicks once, then
release.
To activate the low mode, press the on/off switch until it clicks a second time, then release.
The light can also be operated in “momentary” mode. Momentary mode is activated by
partially depressing the on/off switch (less pressure than required for a full click). The
momentary switch will cycle the light through the high and low beam modes.
Any time the light is turned off for more than five seconds, the high/ low cycle will reset and the
high beam will be activated when the light is turned on again.
NOTE: Some versions of the HP17 include a strobe mode. Strobe mode is activated in the
second position of the quick cycle switch.
Pure Beam Focusing Optic with Speed Focus
This flashlight is equipped with COAST’s Pure Beam™ Focusing Optic with Speed Focus™ that
allows the user to choose between a broad flood beam and a focused Bulls-Eye Spot™ beam for
long distance illumination.
To adjust the beam into the Bulls-Eye Spot™ mode, slide the head of the light all the way
forward.
To adjust the beam into the broad, flood light mode, slide the head of the flashlight back.
The beam can be locked into any position, from full flood beam to spot beam. To lock the beam
in position, turn the head of the light to the left.