beautypg.com

Coast HP7TAC User Manual

Coast Lighting

background image

HP7TAC Instructions:

Battery Installation

Turn the end cap in a counter-clockwise direction to remove the cap.

Remove the battery cartridge.

Place four AAA batteries into the cartridge in the direction indicated on the cartridge.

Replace the cartridge in the light with the red end going in first.

Replace the tail cap and turn it clockwise to tighten it until it is fully closed.

Note – the HP7TAC in clampack packaging ships with batteries installed.

Quick Cycle Switch Operation

This flashlight is equipped with COAST’s Quick Cycle Switch™, featuring high, strobe and low beams.

To activate the high beam from the off position, press the on/off switch until it clicks once, then
release. Press the on/off switch until it clicks a second time to turn off the light.

To activate the strobe mode, press the on/off switch until it clicks a third time, then release.
Press the on/off switch until it clicks a fourth time to turn off the light.

To activate the low mode, press the on/off switch until it clicks a fifth time, then release. Press
the on/off switch until it clicks a sixth time to turn off the light.

The light can also be operated in “momentary” mode. Momentary mode is activated by
partially depressing the on/off switch (less pressure than required for a full click). The
momentary switch will cycle the light through the high, strobe and low beam modes.

Any time the light is turned off for more than five seconds, the high/ low cycle will reset and the
high beam will be activated when the light is turned on again.

Pure Beam Focusing Optic with Speed Focus

This flashlight is equipped with COAST’s Pure Beam™ Focusing Optic with Speed Focus™ that
allows the user to choose between a broad flood beam and a focused Bulls-Eye Spot™ beam for
long distance illumination.

To adjust the beam into the Bulls-Eye Spot™ mode, slide the head of the light all the way
forward.

To adjust the beam into the broad, flood light mode, slide the head of the flashlight back.

Maintenance: Wipe the external body with a damp cloth. Do not submerge.