CNB INS1000 - Manual (Page 2)

XNET Network Video Server User’s Guide
If you would like to use the XNET for security, monitoring, please check the legal regulations
within the country.
Use only the power adapter provided with the XNET.
Do not disassemble XNET. You will be excluded from After Service when disassembled.
Be careful not to cause any physical damage by dropping or throwing the XNET. Especially keep
the device out of reach from children.
Directions
XNET are designed for indoor use only. When using XNET outdoors or in an environment that
exceeds the limited range, you must separately use a water-resistant case.
z Consult the dealer or an experienced radio/TV technician for help.
z Connect the equipment into and outlet on a circuit different from that to which the
receiver is connected
z Increase the separation between the equipment and receiver.
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generate, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
Note
Any changes or modifications in construction of this device which are not explicitly approved
by the party responsible for compliance could void the user’s authority to operate the
equipment.
Caution
2 of 44