CNB IG1810PF - Manual (Page 13)

XNET Network Box Camera User’s Guide
Wireless.
ect it to desired LAN.
through a IP sharing device (i.e.
twork (i.e. the internet), in order to access each unit from outside
vice to forward packet data with
unique port number (RTSP and HTTP) to unique internal IP address (local IP address). If
in-
between the client and the IP video products. For more detailed information regarding
.2. Connecting to xDSL/Cable Modem
ps ① to ③ in Section 2.5 to assign IP address and other network
nstall XNET/XNET-Wireless and connect it to xDSL or Cable modem as in Figure 3-2.
Figu m
②
XNET
2) Install the viewer program (NVR or XNVR) and conn
3) Check if you can receive video data when connecting to XNET/XNET-Wireless using the
viewer program.
4) When one or more IP video products are connected
router) to a larger ne
the local area network, each device must have a unique RTSP (Real Time Stream
Protocol) and HTTP port number. You must also configure your IP sharing device for
“port forwarding”. This is to enable the IP sharing de
you only plan to access multiple units from within a local area network, you do not n
to change the RTSP and HTTP port numbers, unless other IP sharing devices sit eed
the use of IP sharing device refer to the document [Use of Private IP network using
IP-sharing-device] .
3
1) Follow through ste
parameters to XNET/XNET-Wireless.
2) I
IP Network
(LAN/WAN)
re 3-2. Connecting the XNET to ADSL Mode
xDSL/
Cable
Modem
Client PC
13 of
47