5bx10 programming, X10 programming – INSTEON In-LineLinc Relay (Dual-Band) (2475SDB) Manual User Manual
Page 8
Page 8 of 12 2475SDB - Rev: 1/21/2014 7:58 AM
Resetting In-LineLinc to its Factory Default Settings
The factory reset procedure clears all settings from In-LineLinc, including INSTEON links, X10 addresses,
etc.
Option 1
1) If possible, remove all scene memberships prior to performing the factory reset.
2) Press & hold the Set button on In-LineLinc until it beeps
LED will blink
3) Press & hold the In-LineLinc’s Set button until it beeps again
In-LineLinc’s LED will blink
4) Double-tap the Set button, then immediately press & hold it until the long beep stops
In-LineLinc’s LED will turn off
In-LineLinc will emit a long ((((((Beep))))))
Option 2 – two people required
1) If possible, remove all scene memberships prior to performing the factory reset.
2) Turn circuit breaker off
3) While Pressing & holding In-LineLinc’s Set button, have a friend turn the circuit breaker back on
As you continue to press & hold, In-LineLinc will (Beep)
4) Continue to press & hold the Set button for 3 seconds, then release
As soon as you release the Set button, the In-LineLinc LED will turn on solid white and
then dim. After a few seconds, In-LineLinc will (Beep)-(Beep).
X10 Programming
Instructions on setting X10 primary address and scene addresses can be found online: