INSTEON OutletLinc Dimmer (Dual-Band) (2472DWH) Manual - Manual (Page 9)

Page 9 of 13 2472D - Rev: 1/21/2014 7:48 AM
Blink LED on INSTEON Traffic
This feature can be enabled (and subsequently disabled) via compatible software packages.
Beep on Local Set Button Presses
This feature can be enabled (and subsequently disabled) via compatible software packages.
Factory Reset
The factory reset procedure clears all settings from OutletLinc, including INSTEON links, on-levels, ramp
rates, X10 addresses, etc.
1) If possible, remove all scene memberships prior to performing the factory reset.
2) Turn off circuit breaker.
3) Press and hold OutletLinc’s Set button. Do not let go.
4) Have a friend turn on the circuit breaker.
As you continue to press and hold, OutletLinc will begin to emit a long beep.
5) When beep stops, release Set button.
The OutletLinc LED will turn on solid green and then turn off.
After a few seconds, OutletLinc will double-beep.
LED state depends upon other factors (see the
LED status table for more information).
X10 Programming
Instructions on setting X10 primary address and scene addresses can be found online:
http://www.smarthome.com/insteon-x10-programming.html
Specifications
General
Product Name
OutletLinc Dimmer - INSTEON Remote Control Dimmer Outlet
(Dual-Band)
Brand Smarthome
Manufacturer Product Number 2472D
UPC
White - 2472DWH: 813922010251
Almond - 2472DAL: 813922010220
Light Almond - 2472DLAL: 813922011630
Black - 2472DBK: 813922010237
Gray - 2472DGY: 813922011364
Ivory - 2472DIV: 813922010244
Brown - 2472DBR: 813922011357