INSTEON OutletLinc Dimmer (Dual-Band) (2472DWH) Manual - Manual (Page 5)

Page 5 of 13 2472D - Rev: 1/21/2014 7:48 AM
Set Button
Tap the Set button to toggle connected lamp on and off. Press and hold (as per instructions) to manage
other properties and INSTEON scenes (as per instructions below)
Load Sense
If outlet is off, then turning on the connected load (e.g. lamp) via manual adjustment (e.g. rotating lamp’s
on/off knob) will result in the outlet turning on.
Beeper
- Single beep: transition from one setup mode to another
- Double-beep: successful scene addition or removal
- Continuous beeps for 3 seconds: unsuccessful scene management or 4-minute setup timeout
LED
LED
Steady-on green Load is on (at any dim level)
Steady-on red Load is off
Blinking red slowly Device is plugged in without Dimmer Key installed, or
Dimmer Key removed from OutletLinc (10 seconds), or
Dimmer Key missing and INSTEON message received, or
OutletLinc Dimmer is overheating
Optional blink-on-traffic is turned on,
and blinking
red quickly
Dimmer off and INSTEON traffic received
Optional blink-on-traffic is turned on,
and blinking
green quickly
Dimmer on and INSTEON traffic received
Setting up INSTEON Scenes
One or more INSTEON responders that respond to an INSTEON controller create an INSTEON scene.
When the scene is activated (devices turned on), all devices return to the states they were at when the
scene was programmed.
INSTEON scenes let you activate dramatic whole-room changes at the touch of a button. For example,
you can set all the lights in a scene to dim to 50% or turn certain lights on while turning others off, all with
the tap of a single INSTEON controller button.
INSTEON scenes are easy to set up; just follow the directions below.
Adding OutletLinc to a Scene as an INSTEON Responder
1) Plug lamp into bottom outlet and use lamp’s switch to turn it on.
2) Plug lamp (with dimmer key installed) into top outlet.