Adaptec 5ANA-940 - Manual (Page 51)

5-3
Installing ATM Version 2.0x Drivers for Windows NT
Select Add next to the PVCs list box. The PVC Configuration
dialog box appears.
Set the parameters in the dialog box as follows, and select OK:
7 Change any of the editable parameters in the Adaptec ATM
Base Driver/CIP Configuration dialog box, and select OK.
Parameter Setting
VCI Type a number from 32 to 1023.
Null Encapsulation Select the check box to access another
ATM adapter that uses null
encapsulation or VC multiplexing. If
you do not select this check box, the
default transmission method, LLC/
SNAP (RFC 1577), is used.
Remote IP address If you selected the Null Encapsulation
check box, the Remote IP address
parameter appears. Enter the IP
address of the other ATM adapter with
which you want to communicate.
Parameter Setting
Directory This read-only field contains the
directory where the ATM software is
located.
Port Index Leave this parameter at its 0 default
setting; the Port Index parameter is not
implemented at this time.
IBM Concentrator 8282 Select the check box if you have an
ANA-5910 and are connecting to an
IBM Concentrator 8282.
Autostart Base driver Select the check box to automatically
start the base driver at boot-up.