Adaptec 5ANA-940 - Manual (Page 42)

4-14
ANA-5910/5930/5940 User’s Guide
Using Device Drivers and Utilities
Stopping ATM Drivers
To stop ATM drivers:
1 If your path is not set up, change to the following directory:
\winnt\system32\adptaatm\bin
2 Stop the driver using the appropriate command below and in
the following order:
Starting ATM Drivers
To start the ATM drivers
1 In the Program Manager’s Main group window, select the
MS-DOS Command Prompt
icon.
The Command Prompt window appears.
1 If your path is not set up, change to the following directory:
\winnt\system32\adptaatm\bin
2 Start the drivers you need by entering the commands in the
following order:
Various command-line options are available for each utility. You can
get help for any of the commands listed in this appendix by typing
-h after the utility, for example:
aatmcnfg -h
alancnfg -s stops the alane.sys driver
aatmcnfg -s stops the atmo.sys driver
aatmcnfg starts the atmo.sys driver; use the -q option if
you do not want to use SVCs and if you do not
want to register with an ATM switch (for
example, in back-to-back connections); use the
(-a) option if your switch does not support ILMI
address registration
alancnfg starts the alane.sys driver