Hach-Lange FILTRAX eco - Manual (Page 32)

32
Operation
4.3 [+DEVICEDATA] menu
This menu is used to adjust instrument parameters to suit the
respective application conditions.
Note: Normal operation continues while the instrument is in this menu. If
no buttons are pressed for over ten minutes, the instrument automatically
switches to the operation display.
+SERVICE
for maintenance and functional tests
EXTRACTION
PREPUMP
FILTERCLEANING
+OP.COUNTERS (display and reset)
+TEST OF FUNCT.
+SIGNALS
+DEVICEDATA
STATUS (output of detailed error messages and
acknowledgement)
+OP.COUNTERS
(display only)
CLEANED in the
MODUL
PUMPTUBES
PUMP CASSETTE
PUMP WHEELS
AIRFILTER CASE
4.2 Overview of control unit menu
4.3.1 Overview of +DEVICEDATA menu
+DEVICEDATA Setting Description
 CONTRAST –20 to +20
Improves the readability of the display. (Readability
depends on the viewing angle and the
temperature).
LANGUAGE D, GB, NL, F, I, E, PL, S
German, English, Dutch, French, Italian, Spanish,
Polish, Swedish
HEATER On, off, timer (time control
Mode of operation for the tube heaters
Initial setting: timer
HEAT.START January to December
Heated activated at the beginning of the selected
month
Initial setting: October
HEAT.STOP January to December
Heating deactivated at the end of the selected
month
Initial setting: March
DATE Date setting
TIME Time setting
PASSWORD 4 characters using digits 1–4 Password protection on activation
SW-VERSION Information only Instrument software version
SW-CO.PROC. Information only Coprocessor software version