5 identification and authorization level, 6 warning windows, Identification and – Hach-Lange ORBISPHERE 410 User Manual User Manual
Page 38
36
User Interface
4.2.5 Identification and authorization level
Note:
To get to level 0, press the unlock button and OK, without entering any ID or password.
4.2.6 Warning windows
Figure 23 Identification
window
Once the access rights have been set, (
) it is necessary to log in as an authorized user to get
access to the instrument functionalities and settings.
Press the closed padlock
for two seconds to open the
identification window. The user identification and password
must be entered to access functionalities authorized by the
security level of the given user (5 levels available. See
For security, when the session inactivity delay period has
expired (adjustable, via
Configure security on page 80
), the
user is logged off automatically.
Figure 24 Warnings
At various stages, a warning message may be displayed to
request confirmation from the operator that his last action(s)
must really be saved or cleared, or that there is a problem that
did not enable the requested action, such as during
instrument calibration (example shown left).